Awesome gauge, works perfect. Figure out a clip method for it and you're golden.
Make sure if you are trying for PSI you get Imperial.
ScubaPro 2 Gauge Dive Console
By
MarkN
Worked fantastic very easy to read
This Scubapro Pressure Gauge is a durable brass cased design with impact resistant boot. Pressure gauge monitors your air supply as a primary or as a back-up to your air integrated dive computer. Gauge has 0 to 5000 psi readout with pressure increments of 500 psi and 1000 psi increments from 1000 to 5000 psi. Gauge is easy to read in low light conditions with its luminescent dial. Gauge boot is equipped with eyelets for attachment of a lanyard or clip. Gauge hose is 34.5" (87.5cm) long and has a 7/16" threaded end. Gauge weighs 14.4 oz. (408 g).
This product can only be shipped to U.S. addresses.
Shopper
Can you please tell me the outer diameter of the brass gauge in inches? I am looking to replace my old gauge in a Cochran Commander boot. Thanks,
TROY W
2 1/8”
ZAK K
Unfortunately, the boot is a very snug fit and I while I'm sure I could get it all the way off, getting it back on may not be so easy. However, I can pull it back far enough to tell that it is 2" OD. This is measured with a wooden ruler, so keep in mind the accuracy. Scubapro being made in Italy, it is most likely an exact, metric measurement and not exactly 2".
Shopper
I already have this gauge I like it just fine however I need another gauge console to add a compass and the depth gauge can you help me do that?
RICHARD S
Sure, check out the two and three gauge in line consoles under scuba gauges at leisurepro
John T
What is overall diameter of this pressure gauge? Looking for 55mm to fit into existing console.
B C
This is 55mm
Lee S
what is the face diameter of the face of spg scuba pro $124.00 ?
JON H
This brass and glass gauge is 1.75 inches across the face and is very readable to 50 psi. This is one of the biggest gauges currently available (but smaller than their depth gauge). Historically, Scuba Pro made a pressure gauge even larger and the same size as their large depth gauge.
RANDY S
with the rubber case on = 2.3"
with rubber off, metal bezel = +/- 2.085"
Erik R
andrew, thanks for the reply.
ill place the gauge together with my inflation hose which is 23 inches length, 34 inches is too long. do you have shorter hose? thanks