Rating: A well built piece of hardware
Reviewer: Zdenek Nagl,
The manifold allows adjustment between 209 and 215 mm to exactly match bands. Even though the threads allow a wider span, the second set of o-rings would not seal any more if any wider span was chosen!
Knobs are of a nice density, don’t slip, would not crack in case of a slight impact, spin about 1 ¾ turns between the on and off positions, and are very smooth to operate. The overall finish is very nice.
Even though, this is only my second manifold I have ever purchased, I could not find a single reason for cutting down on the number of stars.
Zdenek Nagl, Canada
Did this Review help?
YesNo
334 out of 664 people found this review helpful.
Questions and Answers for XS Scuba 300 Bar DIN Tank Manifold:
Dan:
Would this manifold fit my X7 Hp steel 100s?
Thank you for your help, also would I need to have it o2 cleaned at my LDS
Thank you
Clarke (Certified Scuba Instructor at Scuba.com)
:
Handwheels - One and one half turns of the handwheels from fully on to fully off
One Piece Safety - Protected within body to guard against damage during transport
O-Ring Sealed Boonet - no copper crush washer, 11/16" hex socket head
XS Scuba Isolation Manifold - Either PRO Outlets or DIN OUtlets.
MOdular Access Plugs - Right and left hand plugs are included. Everything included to remove the crossbar and use as single valves.
High Flow - unsurpassed gas flow, allows optimum regulator performance, direct placement porting
On/Off Seat Assembly - Machined high tensile brass alloy, nylon high pressure seat material. Teflon plated for years of smooth operation.
100% Valve Testing - Eight step factory testing on every valve. Every valve pressurized to full working pressure. CGA tested and approved.
Chrome Finish - Triple bright chrome plating, provides long lasting protection from salt water.
Inlet Thread - 3/4 x 14 NPSM threads. Standard for nearly all DOT aluminum scuba cylinders. Standard for all DOT modern steel scuba cylinders.
Hex Wrench Tighted Dip Tube - Say goodbye to pliers. Say goodbye to damaging the chrome plating. Use a 5/32 hex wrench to tighten dip tube.
Gas Service - PRO: Clean for pre-blended Nitrox up to 40% oxygen. VIton and EPDM o-rings. Christo-lube MCG 111 lubrication. Nylon High pressure seat material. DIN: Air service only.
Brass Stem - Precision machined from high tensile brass. Chrome plated for years of corrosion free service
Safety Handwheel - Standard on all models of XS scuba valves. See at a glance the wheel is 100% open. Red/Green. Stop/Go.
FULL MANUFACTURER’S WARRANTY 
![Safety Handwheel - Know at a glance that your valve is fully on](javascript:void(info("/images/regulators/safetyhandwheel.jpg"))){kind=link}