BUY THIS...

TUSA TUL-400 L.E.D. Light TUL-400MDR 026967

GET THIS FREE


Mfg Part #: TUL-400MDR
Retail:
 $94.00 
You Pay:
$87.95
You Save:
$6.05
1 Questions
1 Answers
  • Free Wrist Lanyard Included
  • Free 3 AAA Batteries Included
  • State of the art ultra bright L.E.D. (Light Emitting Diode Technology)
  • High Intensity White L.E.D. light travels farther underwater for maximum visibility and truer colors
  • 3 power levels: 100%, 30%, Strobe
  • Rear magnetic push button On/Off switch
  • Shock and Impact resistant L.E.D. bulb - will not break when dropped
  • Rugged anodized aluminum construction
  • Triple O-Ring, Screwed battery compartment
  • 60 TIMES Longer Bulb Life - 20,000+ Hours!
  • BURN TIME: 100%: 2 hours, 30%: 7 hours
  • BATTERIES: 3 AAA Batteries
  • DEPTH: 400 feet
  • FULL MANUFACTURER’S WARRANTY

Customer Reviews for TUSA TUL-400 L.E.D. Light:

See the top 20 most helpful scuba gear reviews

No reviews found for this product.

Questions and Answers for TUSA TUL-400 L.E.D. Light:


  • Julie:

    how many lumens at full power?

    Bob  (Certified Scuba Instructor at Scuba.com):

    165 Lumens

TUL-400 TUSA Tul 400 LED Dive Light

The TUL-400 is a compact 165 lumen LED light with a 60 degree beam angle that is powered by three AAA cells. Ideal for a daytime accessory light or for a night time backup, it is a great companion to our high-powered TUL-1000. The light offers 3 power modes, 100%, 30% and strobe (flashing) with a run time from 120 to 420 minutes. A compact and streamlined anodized aluminum body with triple o-ring screwed battery compartment and rear magnetic push button switch combine for a depth rating of 400ft/120m.


FEATURES
> 165 Lumen high-powered LED

> Beam Angle: 60 degrees

> 3 Power Levels: 100%, 30%, Strobe

> Run Time: 100%: 120 mins, 30%: 420 mins

> Switch: Rear magnetic, push button on/off

> Depth Rating: 400ft/120m

> Body: Rugged anodized aluminum, metallic dark red finish

> Battery compartment: Triple O-Ring, Screwed

> Accessories: Wrist Lanyard (included)

> Batteries: 3 AAA (included)

> Overall Length: 5.1' / 130mm

TUSA WATERPROOF FLASHLIGHT USER MANUAL

FEATURES

This stylish waterproof ashlight is compact yet bright, using a long life CREE-XPG LED for
maximum eect. The magnetic tail switch features variable power control: push one time
for 100% power, 2 times for 30% power, 3 times for o. From any setting, push and hold
switch for 3 seconds to activate emergency strobe. The magnetic switch eliminates water
leakage often seen in conventional models and has a high capacity to withstand pressure.
CAUTION: Make sure to only use equally charged batteries-do not mix and match. Never
mix Alkaline and Lithium batteries.

SWITCH CARE: Because a magnet is used in the tail switch section, tiny naturally occurring
iron particles (iron sand) can accumulate on the switch during diving. After every dive,
wash thoroughly in fresh running water to remove any such iron sand, as well as dirt and
salt. The push button switch is designed to allow water to enter switch area. It is very
important to ush salt water from chamber. Hold switch under ow of cool fresh water.
Turn upside down and depress switch several times until no more water comes out. Repeat
process 2-3 times to ensure that all salt water is ushed from compartment. Do not drop or
place the ashlight on sand or dirt, since iron sand may stick or go into switch section.

HOW TO REPLACE THE BATTERIES

1) Turn the switch end cap at the rear of the ashlight’s body counter-clockwise and remove it.
2) Slide out battery cradle and remove depleted batteries.
3) Install (3) fresh AAA batteries into the cradle. Follow the +/- polarity as shown.
4) Clean by removing any sand or dirt from screw threads and O-rings on switch end cap and then
apply a small amount of silicone grease on O-rings.
5) Also check and clean (if necessary) the screw threads inside ashlight body.
6) Slide the battery cradle back into the ashlight body, spring-end towards the ashlight head.
7) Once you have inserted the battery cradle, securely tighten the switch end cap back into place
by turning clockwise.
USAGE CAUTIONS


Model# TUL-400MDR (wide beam) or TUL-410MBL (concentrated beam)
BODY BATTERY CRADLE SWITCH END CAP
SPECIFICATIONS
TUL-400MDR (wide beam)
LED: CREE-XPG; 100,000 hour lifetime
Battery: 3AAA
Lumens: 165
Beam angle: 50~60 degrees
Magnetic tail switch: 100% - 30% - hold for strobe
Burn time: 100% - 2 hours consecutive;
30% - 7 hours consecutive
Waterproof to 400 feet / 122 meters
Net weight: 5.82 +/- 0.35 oz, 165 +/- 10g
(without battery and hand strap)
Dimensions: Φ(1.49 x 5.12) inches / (3.8 x 13) cm
Use environment: 0-40 C°
TUL-410MBL (concentrated beam)
LED: CREE-XPG; 100,000 hour lifetime
Battery: 3AAA
Lumens: 220
Beam angle: 5~6 degrees
Magnetic tail switch: 100% - 30% - hold for strobe
Burn time: 100% - 2 hours consecutive;
30% - 7 hours consecutive
Waterproof to 400 feet / 122 meters
Net weight: 5.82 +/- 0.35 oz, 165 +/- 10g
(without battery and hand strap)
Dimensions: Φ(1.49 x 5.12) inches / (3.8 x 13) cm
Use environment: 0-40 C

 

View all TUSA Lights

Choose Currency:

Scuba.com, 1752 Langley Avenue, Irvine CA 92614

US and Canada 800.347.2822
International 001.949.221.9300