NEO SOCK - UNISEX
For added warmth.
FEATURES AND BENEFITS
2mm neoprene anatomically shaped
Intricate multi-panel design
Glued and blind stitched
TECHNICAL SPECIFICATIONS + SIZING
Sizes: USA 6, USA 7, USA 8, USA 9, USA 10, USA 11
Neoprene is a type of foam rubber that was
developed in the 1930s by scientists at DuPont. It
is used in virtually all wetsuits and is generally
laminated on either side with various materials to
produce varying degrees of stretch. BARE suits
generally use four different types of laminates
that produce four different degrees of stretch.
(1) Full-Stretch or 4-way stretch, used in our
ELASTEK suits, (2) Progressive-Stretch, used in
our Velocity series suits, (3) Powerstretch, used
in our Ignite series suits and (4) Standard
stretch used in our Sport s series suits.
What do I need to do before the dive?
When donning your boots be careful not to snag the
inner skin materials of the suit with fingernails,
rings, bracelets etc as this can affect the
sealing performance of your suit.
What do I need to do after the dive?
Prior to removing your boots be sure to unzip all
the zippers completely. Once all the zippers have
been unzipped, make your way out of the boots
taking care not to damage the boots by excessive
pulling or snagging with fingernails, rings,
How should I store my boots?
Salt water and chlorine can reduce the life of
your boots by drying out the neoprene. To keep
your BARE boots looking good and maintain their
health, after the dive you should let your boots
soak in warm freshwater for 30 min. After soaking,
rinse your boots and hang on a wetsuit hanger (a
thin hanger will stretch the suit). Be sure to
pull the zipper down all the way.
Note: Avoid placing your boots on hot surfaces and
storing in the trunk of your car for extended
periods of time.
What should I do about cuts or punctures on my
Sometimes, contact with rocks underwater is
unavoidable. Because of this, it is not uncommon
to get rips and tears in your boots wetsuit. If
you rip or tear your boots you can usually repair
it using neoprene glue by filling in the hole or
tear. Liquid Aquaseal is a common neoprene glue
that can be used for the repair and can be found
at one of our local retailers. Follow the
instructions on the packaging.